AWTS

The Automatic Wire Test Set is a specific configuration of the Eclypse Analyzer that is fully described in the Joint Service Technical Manual NAVAIR (17-15W-1|T.O. 33D7-28-34-1) below is an excerpt from WP 003 00;

The Automatic Wire Test Set (AWTS) is automated test equipment that aids wiring diagnostics of electrical and electronic devices. The Test Control Unit (TCU) uses resistance measurements, capacitance measurements, and AC/DC voltage measurements to perform continuity, insulation, and isolation tests. The AWTS Laptop CPU, hereafter referred to as CPU, controls the AWTS. The Eclypse Language Integrated Test Environment (ELITE) is application software that controls the TCU. The majority of the hardware for a test is contained in the TCU. The 128–pin connector on the TCU front panel provides 128 energizable test points. Switch Modules (SM) can be connected in sequence or daisy chained to the TCU and provide an additional 1024 test points; 128 of those are energizable. The ancillary External Load Module (ELM) connects to the energizable connectors on the TCU and SM. The ELM provides a programmable load to the Unit Under Test (UUT). A 200% circuit breaker overload test is the most common use of the ELM.

For additional questions see below.

To purchase visit our Contact page.