| |
|
|
| |
1.2 - Model 501 & 1502 |
|
| |
|
|
| |
Q: What should I check first if I have no stimulus output
from the analyzer? |
|
| |
A: Each system has a program bus fuse. This bus
supplies the power to both the stimulus and measurement control circuits.
The fuse is located on the front face plate of the power board (or
on the upper left corner of the power board on older model 501 systems).
If fuse is blown, replace with value and type indicated on system
info label (usually on rear panel). |
|
| |
|
|
| |
Q: Where is the systems main AC input fuse? |
|
| |
A: On the portable models the input fuse is located
in the same AC input module as the power switch and the power cord.
Larger systems have an instrument breaker instead of a input fuse. |
|
| |
|
|
| |
Submit a question |
|
