| |
1.5.5 - Testing/Setup |
|
| |
|
|
| |
|
|
| |
Do I need to make up an interface to match the wire type
under test? |
|
| |
|
|
| |
Not generally. The lead set included in the Model ESP includes a
6-foot coax cable for use when wires under test are less than 10 feet.
The supplied cable has an impedance value (estimated at 74.6 Ohm).
If the cable under test varies greatly from this value a mismatch
of impedance occurs. Please reference Failure and Error Mode link
below to view or download. |
|
| |
|
|
| |
If I know there is a problem in only one wire what to I
connect the other lead to? |
|
| |
|
|
| |
Ideally, a wire of the same type and length that runs parrallel
down the same path. |
|
